Need Help?
Replies within one business day
NV4500 Manual Trans for 1996-2000 GM P-series, 2WD
$2,649.00
- Quality inspections are conducted 3 times during the remanufacturing process
- A pre-inspection is done to ensure the unit is free of case cracks, excessive wear and to catch other OEM related problems that many cores have
- A second inspection is conducted during the reman process to ensure all component parts meet OEM specifications
- A final post-build inspection is done to ensure unit is built to our strict standards
- 100% inspection of internal parts, including gear wear checks, mainshaft straightness test and synchronizer testing.
- All transmissions are dynometer tested and ran through numerous real life scenarios.
Warranty and refundable core terms confirmed before purchase.
NV4500 Manual Trans for 1996-2...
$2,649.00
Need Help?
Replies within one business day
***Please understand that in the event this is being purchased for a swap CORES are very rare on these and if you do not have the same core to return you will be required to pay the core charge in full****
Application Notes:NV4500; Cast Iron Case, Detachable Bell Housing, Internal Slave Cylinder, Square Four Bolt Shift Tower, Reverse Is Not Synchronized, Has Emergency Brake Mounted On The Tail Housing (Not Included), Uses A Bolt To Hold The Rear Output Yoke On And Not A Nut, 1.771 Diameter Seal Surface On The Yoke, Main Case Cast 18157, 23167, Or 33903, Top Cover Cast 18860, or 25137, Tail Housing Cast 23337NV4500; Cast Iron Case, Detachable Bell Housing, Internal Slave Cylinder, Square Four Bolt Shift Tower, Reverse Is Not Synchronized, Has Emergency Brake Mounted On The Tail Housing (Not Included), Uses A Bolt To Hold The Rear Output Yoke On And Not A Nut, 1.771 Diameter Seal Surface On The Yoke, Main Case Cast 18157, 23167, Or 33903, Top Cover Cast 18860, or 25137, Tail Housing Cast 23337.
Remanufacturing Process
Every unit is fully remanufactured and covered against defects in materials and workmanship. Email us to confirm the current warranty term for this unit before purchase.
- Teardown and Triple Clean – Every transmission is disassembled, inspected, and cleaned three times. We also chase all threads and install all new bushings during this process.
- New or Re-machined Parts – Gear wear is checked and worn gears are replaced. Mainshaft straightness is tested and replaced if needed. Clutch disc synchronizers, selector fork, and flywheel are re-machined or replaced as needed.
- Dyno Testing – Our custom dyno testing machines spin and load test every transmission to verify it’s ready for the road.
Every unit is fully remanufactured and covered against defects in materials and workmanship. Email us to confirm the current warranty term for this unit before purchase.
